Beltronics RX45 - Manual (Page 8)

There are 5 user-selectable programming
options on the RX45. This allows you to set
it up the way you prefer.
To access Programming, simply press
the buttons that are normally used for
brightness (BRT) and sensitivity (SENS) at
the same time. Once you access
Programming, the BRT button is used to
review (RVW) the categories and the SENS
button is used to change (CHG) items
within the category. Pages 14-15 explain
each option in more detail.
How to use Preferences
1
To enter Programming, press both
buttons and hold for 2 seconds. The
RX45 will beep and display
Program .
(Brightness is at maximum during this
process.)
2
Then press the RVW button to review
the current settings. You can either tap
the button to change from item to item, or
hold the button to scroll through the items.
3
Press the CHG button to change any
setting. You can either tap the button to
change from setting to setting, or hold the
button to scroll through all the options.
4
To leave Programming, simply wait 8
seconds without pressing any button.
The unit will display
Complete , beep and
return to normal operation.
To quickly return to all of the factory
defaults, press and hold the BRT and SENS
buttons while turning on the unit.
Press the REVIEW button
to go from one category
to the next
PILOT LIGHT
(Power-on indication)
SIGNAL STRENGTH METER
AUTOMUTE
VOICE
BANDS
*
Factory Default Settings
To reset the RX45 to its original
factory settings, press and hold
the “BRT” and “SENS” buttons
while turning the power on.
The display will provide a
Reset message, accompanied
by an audible tone,
acknowledging the reset.
An example
Here’s how you would turn the RX45’s
AutoMute feature off.
1 Enter Programming by holding both
buttons down for 2 seconds. The RX45 will
beep and display
Program .
2 Then hold the RVW button down.
The RX45 will scroll through the categories,
starting with Pilot (
Pilot ), then Signal
Strength Meter ( Meter ), then AutoMute
( aMute ).
3 Release the RVW button when the
display shows
AutoMute . Since the
factory setting is for AutoMute to be on,
the RX45 will display
aMute ON .
If you accidentally don’t release the
RVW button in time and it goes to the
next category, simply hold the RVW button
down again until
aMute is displayed.
4 Press the CHG button to change from
aMute ON to aMute OFF .
5 To complete this change, simply wait 8
seconds without pressing any button. The
display will provide a
Complete message,
accompanied by an audible tone. This is
an indication that the RX45 has returned
to its normal operation.
Pilot HWY
Pilot H
Pilot V
Meter STD
Meter THT
Meter TEC
aMute ON
aMute OFF
Voice ON
Voice OFF
Bands DFT
Bands MOD
X ON or OFF (default is on)
Ku ON or OFF (default is off)
K ON or OFF (default is on)
Ka ON or OFF (default is on)
POP ON or OFF (default is off)
SWS ON or OFF (default is off)
LSR ON or OFF (default is on)
TSR ON or OFF (default is off)
Press the CHANGE button
to change your setting
within a category
* Full word: Highway, AutoScan, AutoNoX
Letter: H or A or ANX
Vehicle voltage
* Standard signal strength meter
ThreatDisplay
TechDisplay
* AutoMute on
AutoMute off
* Voice alerts on
Voice alerts off
* Factory default settings
One or more bands have been changed
Turn bands on or off by pressing
and holding the V•MUTE button
How to use Preferences
12
Overview of Preferences
13