Bang & Olufsen BeoVision MX TV User Manual
Page 9
9
What’s on the first Tuning menu…
Freq
The frequency of the stations. You prompt the TV
to search for a station. The tuning stops at the
first station producing an acceptable signal.
If you wish to continue searching, press
▲
or
▼
again. If you know the exact frequency, you can
key it in directly*.
*Note: See the list on page 11 for a conversion of
TV channel numbers to frequencies.
Fine
Fine tuning of a station. The TV automatically
tunes to the best possible picture. If neighbouring
channels blur the picture slightly, fine tuning may
be necessary.
You fine tune by 1 step below or above the
standard frequency.
System
TV broadcast system – select the TV broadcast
system which is available or most appropriate:
For example:
B/G
PAL/SECAM B/G system
L
SECAM L system
I
PAL I system
Note: Not all TVs are equipped to receive all
systems.
Decoder
If you need a decoder for a station – the TV can
cut in a decoder automatically for the station in
question. On indicates cutting the decoder in
and Off no decoder. In order for Decoder to
appear on the menu, however, you must
register your Decoder, see Registering extra
equipment, pages 34-35 for further instruction.
What’s on the second Tuning menu…
Pg
Program number – you can use the program
numbers 1-59. The indication – shows that the
frequency has not already been tuned in to.
If the station/frequency has already been stored,
a program number appears under Pg when you
call up the second Tuning menu.
Name
A name may contain 10 characters (indicated by
the 10 dots in the menu), including the letters
from A to Z, numbers and full stop. The first of
the 10 dots blinks, indicating that you can start
“writing” a name.
You must reveal the characters for the positions
you wish to fill in. Press
▲
until the letter you
want is revealed, press
tt
to move to next
position and press
▲
or
▼
to reveal letters. To
switch from upper to lower case, or vice versa,
press 0.
When you start “writing” a name, the dots
disappear. The name is automatically
transferred to the program list. See the next
page for further details of the program list.
Every time you select a station you have named,
the name appears briefly on the screen.
Sound
Several types of sound may be available for a TV
station e.g. both stereo and mono sound, or
two or three different languages. You can
choose to store a specific type of sound or
language with your station.
The options are…
Mono
Mono sound
Stereo
Stereo sound
Mono-1
Language 1 – mono
Mono-2
Language 2 – mono
Mono-3
Language 3 – mono
Stereo-2
Language 2 – stereo
Store
Finally, accepting Store stores your station and
returns you to Tuning in the Setup menu and you
can now choose to continue tuning. You
still have an opportunity, though, to remove all
the data you have entered by revealing Clear
instead of Store in the menu. Use
▲
or
▼
to
reveal Clear instead of Store and then press GO.
Clearing a stored station…
If you want to clear a station, you have tuned
in already, switch on to the program number
you want to clear, then call up the second
Tuning menu as explained on these two pages.
Once the menu appears, make
sure that the correct program number is
displayed, move to Store and press
▼
to
reveal Clear instead of Store and press GO.