Sharp LC-60LE651K - Manual (Page 13)

Reception of a single satellite via a connected LNC
(LNB).
1 Select satellite.
Press J
to continue.
2 Select Dual Band (low/high) or Single Band.
Here you specify if you use a Dual Band (Universal)
LBN or Single LBN.
Press J
to continue.
3 Specify here the oscillator frequency for your LNB.
Normally you do not need to change the values
for high and low band, unless the LNB of your
satellite system uses a different oscillator frequency
(important for the frequency display).
If you use the setting Single Band in step Dual/
Single Band,
you only have to define the LNB
frequency for the Low Band.
4 Press J
to continue.
See Setting options for all DVB-S reception on
page 13
to continue.
Quick guide
1 Select Satellite1/Satellite2
2 Select satellite name from list and press OK.
Press J to continue.
3 Specify here the oscillator frequency for your LNB.
Normally you do not need to change the values
for high and low band, unless the LNB of your
satellite system uses a different oscillator frequency
(important for the frequency display).
4 Press OK to select frequency and press J to
continue.
See Setting options for all DVB-S reception on
page 13
to continue.
Select DiSEqC multiswitch and adpat settings for this
selection.
11
Setting options for Single satellite
Setting options for Max. 4 satellites on DiSEqC
multiswitch
Setting options for 2 satellites on 22kHz
switchbox / 2 satellites on Toneburst switch