Sharp GX-BT3 - Manual (Page 10)

E-9
Connecting other equipment
1 Use a connection lead to plug in the portable audio
player, etc. to the AUDIO IN socket. When using video
equipment, plug in the audio output to this unit and the
video output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the AUDIO IN button on the remote control or
FUNCTION button repeatedly on the main unit to select
AUDIO IN function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may oc-
cur. Should this happen, lower the volume of the con-
nected device. If volume level is too low, increase the
volume of the connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ Listening to the playback sounds of
portable audio player, etc.
GX-BT3
Portable audio
player, etc.
Audio cable (not supplied)
Troubleshooting chart
Many potential problems can be resolved by the owner
without calling a service technician.
If something is wrong with this product, check the fol-
lowing before calling your authorised SHARP dealer or
service centre.
■
General
Symptom Possible cause
 When a button is
pressed, the unit
does not respond.
 Set the unit to the power
standby mode and then
turn it back on.
 If the unit still malfunctions,
reset it. (Refer page 10)
 No sound is heard.  The volume level is set to
minimum.
■ Remote control
Symptom Possible cause
 The remote control
does not operate.
 The AC power lead of the
unit is not plugged in.
 The battery is exhausted.
 The distance or angle is
incorrect.
 The remote control sensor
receives strong light.
■ NFC / Bluetooth
Symptom Possible cause
● No sound is heard. ● The unit is too far from the
Bluetooth stereo audio
source device.
● The unit is not paired
with the Bluetooth stereo
audio source device.
● Bluetooth sound
is interrupted or
distorted.
● The unit is too near to
a device that generates
electromagnetic radiation.
● There is an obstacle
between the unit and the
Bluetooth stereo audio
source device.
● NFC-enabled device
cannot connect to
Bluetooth via NFC tag.
● Main unit is not in
Bluetooth pairing mode.
Perform “NFC connection
for audio playback”.
(Refer page 6.)