Sharp EL-1611E - Manual (Page 13)

11
RESETTING THE UNIT
Strong impacts, exposure to electrical fields, or other unusual
conditions may render the unit inoperative, and pressing the keys
will have no effect. If this occurs, you will have to press the RESET
switch on the bottom of the unit. The RESET switch should be
pressed only when:
•
an abnormal event occurs and all keys are disabled.
• you install or replace the batteries.
Notes:
•
Pressing the RESET switch will clear the stored exchange rate
and other data stored in the memory.
• Use only a ballpoint pen to press the RESET switch. Do not use
anything breakable or anything with a sharp tip, such as a needle.
• After pressing the RESET switch, press to make sure that
“0.” is indicated.
PRINTING SECTION
Printing speed: Heavy-duty manganese battery, size AA
(or R6)
Approx. 2.1 lines/sec. (At temperature
25°C(77°F), when “741 • 9 +” is printed.
Printing speed will vary with the number
of rows, different figure types to be
printed, and the charge level of the
batteries.)
Printing paper: 57 mm (2-1/4") – 58 mm (2-9/32") wide
80 mm (3-5/32") in diameter (max.)
Operating temperature: 0°C – 40°C (32°F – 104°F)
Power consumption: 6V (DC): 1.7 W
Dimensions: 99 (W) × 191 (D) × 42 (H) mm
3-29/32" (W) × 7-17/32" (D) × 1-21/32" (H)
Weight: Approx. 238 g (0.53 lb.) (with batteries)
Accessories: Ink roller × 1 (installed), Paper roll × 1,
Dry battery (R6) × 4 and Operation
manual