Baby Trend 7311 - Manual (Page 14)

Evenfl o
®
On My Way
®
Please follow the following instructions for proper installation of
your infant car seat.
Installation of the Evenfl o
®
On My Way
®
Infant Car
Seat
1. Place front seat in the reclined position. With one hand grasp
the car seat handle (in its upright, carrying position) and gently
place the seat, so that the baby faces the rear of the Stroller, onto
the Snap-N-Go attachment system so that the large groove on
the seat bottom, nearest the head-end of the seat, hooks over the
Snap Bar. Check that the seat locked onto the Snap Bar.
2. Feed the Car Seat Straps through the auto belt slots on the
infant car seat and snap the two buckles together (see Figure
2). The fi rst time you do this, you will need to adjust the length
of the strap for a tight fi t around the car seat. FOR SAFE
OPERATION, IT IS VERY IMPORTANT THAT THE CAR
SEAT STRAP IS ALWAYS TIGHTLY FASTENED OVER
THE CAR SEAT.
3. Test for secure installation by moving the car seat in all directions.
The car seat should be securely attached to the stroller.
Removal of the Evenfl o
®
On My Way
®
Infant Car Seat
1. Unlock the Car Seat Strap and remove from over the infant car
seat.
2. With one hand, grasp the car seat handle (in its upright, carrying
position) and with your other hand squeeze the red handle on the
back of the car seat and lift the car seat upward from the Snap-
N-Go frame.
Figure 2.
Figure 1.
Snap Bar
Position “V”
Position “1”
14
Cosco ® , Peg Perego ® , Primo Viaggio ® , Evenfl o ® , Cozy Carry ® , On my Way ® , Embrace ® ,
Century
®
, Vante
®
, Graco
®
, Cosco
®
Arriva
®
and Snug Ride
®
are the trademarks of their owners.
They are not associated with Baby Trend, Inc. and no approval or endorsement is implied.