Neff S51M53X1GB - Manual (Page 12)

en Rinse aid
12
1. Open the dispenser 9" by pressing
and lifting the plate on the cover.
2. Carefully pour rinse aid up
to the max. mark in the filler opening.
3. Close cover until it clicks shut.
4. To prevent excessive foam formation
during the next rinse cycle, remove
any rinse aid which has run over with
a cloth.
Setting amount of rinse aid
The amount of rinse aid can be set from
§:‹‹ to §:‹‡. Please set rinse aid on
§:‹† to obtain very good drying results
(
§:‹† is already set in factory).
Change this setting, only if streaks
(select lower setting) or water stains
(select higher setting) are left on the
utensils.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button ` until
•:‹.... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display h displays the
factory setting
•:‹….
5. Press programme button # until
the factory set value §:‹† is
indicated on the digital display h.
To change the setting:
1. Press programme button 3.
Each time the button is pressed, the
set value increases by one level;
when the value of
§:‹‡ has been
reached, the display jumps back
to
§:‹‹ (off).
2. Press START button `.
The set value is saved.
3. Close the door.
Switching off rinse aid refill
indicator
If the rinse-aid refill indicator H is
impaired (e.g. when using combined
detergents containing rinse aid
component), it can be switched off.
Proceed as described under “Setting
amount of rinse aid” and set the
value to
§:‹‹.
The rinse aid refill indicator H is now
switched off.


PD[