Whirlpool WFG510S0AS - Manual (Page 13)

13
Oven burner flames are yellow
or noisy Range converted improperly If propane gas is being used, contact a service technician or
see cover for contact information.
Oven temperature too high or
too low Oven temperature needs
adjustment. See “Oven Temperature Control” in the “Electronic Oven
Controls” section.
Convection fan not working The convection cycle is in the first
5 minutes of operation. This is normal. The convection fan will start running
approximately 5 minutes into the cycle.
Oven door is open. If the oven door is opened during convention cooking, the fan
will turn off immediately. It will come back on when the oven
door is closed.
Display shows messages Power failure (display shows
flashing time) Clear the display. On some models, reset the clock, if needed.
See “Clock” keypad feature in the “Feature Guide” section.
Error code (display shows letter
followed by number) Depending on your model, press CANCEL to clear the display.
See “Control Display” in the “Electronic Oven Controls”
section. If it reappears, call for service. See cover for contact
information.
Start needs to be pressed so a
cycle can begin (display shows
“PUSH” or “PSH”). See the “Start” keypad feature in the “Feature Guide” section.
Range is in Sabbath Mode
(display shows “SAb”). Press CANCEL to exit Sabbath Mode.
Self-Cleaning Cycle will not
operate The oven door is not closed. Make sure the oven door is fully closed.
The Self-Cleaning function has
not been entered correctly. See the “Self-Cleaning Cycle” section.
A Timed Cooking function has
been entered. See the “Cook Time” section.
The range is in Sabbath Mode. See the “Sabbath Mode” section.
A Self-Cleaning cycle has been
run in the past 12 hours. If a Self-Cleaning cycle has been run, or has been canceled
after the oven reached temperature, the oven control requires a
12-hour delay before starting another Self-Cleaning cycle.
Oven cooking results not what
expected Range is not level. Level the range. See the Installation Instructions.
The temperature set was
incorrect. Double-check the recipe in a reliable cookbook.
Oven temperature needs
adjustment. See “Oven Temperature Control” in the “Electronic Oven
Controls” section.
Oven was not preheated. See “Baking and Roasting” section.
Racks were positioned
improperly. See “Positioning Racks and Bakeware” section.
Not enough air circulation around
bakeware See “Positioning Racks and Bakeware” section.
Darker browning of food caused
by dull or dark bakeware Lower oven temperature 25°F (15°C) or move rack to a higher
position in the oven.
Lighter browning of food caused
by shiny or light colored
bakeware Move rack to a lower position in the oven.
Batter distributed unevenly in pan Check that batter is level in the pan.
Incorrect length of cooking time
was used. Adjust cooking time.
Oven door was not closed. Be sure that the bakeware does not keep the door from closing.
Oven door was opened during
cooking. Oven peeking releases oven heat and can result in longer
cooking times.
Rack is too close to bake burner,
making baked items too brown
on bottom. Move rack to higher position in the oven.
Pie crusts browning too quickly Use aluminum foil to cover the edge of the crust and/or reduce
baking temperature.
PROBLEM POSSIBLE CAUSES SOLUTIONS