Baratza Virtuoso - Manual (Page 9)


Use the bristle brush (included with your grinder)
to remove any loose coffee residue on the ring
burr and the center cone burr mounted within the
motor housing. Wash the silicone seal in warm
soapy water and dry.
Replacing the Ring Burr:
Ensure that the red tab on the adjustment ring lo-
cated inside the top of the grinder housing is posi-
tioned as shown in the picture at left. If the red tab
is not in the correct position, turn the adjustment
ring counterclockwise as far as it will go. Replace
the burr by lining up the red tab on the burr with
the red tab on the adjustment ring. Wiggle and
push down firmly on the ring burr to ensure that it
seats properly.
After replacing the burr, replace the silicone seal by lining up the two
slots in the silicone seal with the small tabs on the top of the ring burr
and slide the seal onto the ring burr.
Replacing the Bean Hopper:
To replace the bean hopper, line
up the two small tabs on the base
of the hopper with their respective
slots in the top of the grinder hous-
ing and insert the hopper into the
grinder. Once the hopper is in place
rotate it clockwise to your desired
grind
setting.