Accessories, Problem solver – Whirlpool WMH76719CS User Manual

Page 6

Advertising
background image

6

Following is a list of available parts and supplies which may be purchased separately. Please refer to the cover for contact and model identification
information.

Replacement Parts

Turntable

Turntable support and rollers

Turntable hub

Cooking rack

Rack clip

Rack support

Grease filter

Charcoal filter

Cooktop light bulb

Cavity light bulb

Provided Accessories

Convection rack

Steamer vessel

Cleaning Supplies

Heavy Duty Degreaser

affresh

®

Kitchen Appliance Cleaner

affresh

®

Stainless Steel Cleaner

affresh

®

Stainless Steel Wipes

ACCESSORIES

Scan the code at left with your mobile device, or visit www.whirlpool.com/product_help for
recommendations that may help you avoid a service call.

If you experience

Recommended Solutions

Microwave oven will
not operate

Check the following:

Household fuse or circuit breaker - If a household fuse has blown or a circuit breaker has tripped, replace the
fuse or reset the circuit breaker. If the problem continues, call an electrician.

Magnetron - Try to heat 1 cup (250 mL) of cold water for 2 minutes at 100% cooking power. If water does not
heat, try the steps in the bullets below. If microwave oven still does not operate, call for service.

Door - Firmly close door. On some models, if a packaging spacer is attached to inside of the door, remove it,
then firmly close door.

If a message about the door appears in the display, the door has been closed for 5 minutes or more without the
microwave oven being started. This occurs to avoid unintended starting of the microwave oven. Open and close
the door, then start the cycle.

Control - Make sure control is set properly. Make sure Control Lock is off. Make sure Demo Mode (on some
models) is off.

Arcing in the
microwave oven

Check the following:

Soil buildup - Soil buildup on cavity walls, microwave inlet cover, cooking rack supports, and area where the
door touches the frame can cause arcing. See “General Cleaning” in “Microwave Oven Care” section.

Turntable alternates
rotation directions

This is normal and depends on motor rotation at the beginning of the cycle.

Display shows
messages

“Enter clock” with flashing digits means there has been a power failure. Reset the clock.

A letter followed by a number is an error indicator. Call for assistance.

Fan running during
cooktop usage

This is normal. The microwave oven’s cooling fan, which is separate from the vent fan, automatically comes on
during microwave oven operation to cool the microwave oven. It may also automatically come on and cycle on
and off to cool the microwave oven’s controls while the cooktop below is being used.

Radio, TV or cordless
phone interference

Check the following:

Proximity - Move the receiver away from the microwave oven, or adjust the radio or TV antenna.

Soil - Make sure the microwave oven door and sealing surfaces are clean.

Frequency - Some 2.4 GHz-based cordless phones and home wireless networks may experience static or noise
while microwave oven is on. Use a corded phone, a different frequency cordless phone or avoid using these
items during microwave oven operation.

PROBLEM SOLVER

Advertising