Bacharach 24-9422 - Manual (Page 6)

IrDA Printer
2 Instruction 24-9422
Power Switch
Use the Power switch located on the left side of the printer to turn the
unit ON and OFF (see Figure 1).
Indicator LEDs
There are two LEDs on the front panel that provide the following infor-
mation about the printer’s status:
• Power (Green): The Power LED glows green when the printer is
turned ON.
• Battery (Red): The Battery LED glows red when the battery is being
charged. This LED flashes when the battery is fully charged, and turns
OFF when the battery charger is disconnected.
• Error (Green): The Power LED flashes once-a-second when: 1) the
printer is out of paper, 2) when the paper cover is opened, or 3) when
the printing head temperature exceeds 140 °F (60 °C).
Pushbuttons
There are two pushbuttons located on the front panel that perform the
following functions:
• FEED: Momentarily press this button to advance the paper. Pressing and
holding down the button causes the paper to feed continuously. This button
is also used to start the printer’s self test (refer to Section Self Test).
• SEL: Press this button to enter the printer’s set-up mode (refer to
Section Set-Up Mode).
Connectors
Two connectors located on the right side of the printer provide the follow-
ing functions:
• Power: Connect the AC adapter or in-car charger to this connector to
charge the battery pack, or directly power the printer.
• RS-232C: Not used in conjunction with Bacharach instruments.
Description