B&B Electronics PCRTC - Manual (Page 8)

6 Documentation Number PCRTC2095 Manual
B&B Electronics -- PO Box 1040 -- Ottawa, IL 61350
PH (815) 433-5100 -- FAX (815) 433-5105
The best method of updating the PCRTC time is to use the
shareware program Timeset. Note that although this program is
included on the PCRTC diskette, it is shareware and should be
registered with its author. Timeset uses your modem to obtain the
precise time from one of five atomic clocks in two continents, then
sets your DOS time. The batch file RTCSET.BAT included in the
Timeset directory should be used in conjunction with Timeset.
Running the batch file will execute the following operations. Note
that the device driver PCRTCDD.SYS must be installed to run the
batch file. Before running Timeset or the batch file, you will need to
configure Timeset for your modem and preferences. Documentation
files are included in the Timeset directory.
1. Update the DOS time to the PCRTC time
2. Disable the device driver
3. Run Timeset
4. Update the PCRTC to the corrected DOS time
5. Enable the device driver
Using Timeset allows the PCRTC time to be updated to within
≤
0.1
seconds of the atomic clock selected. The small discrepancy in time
is dependent on the speed of the host computer and background
activities on the host computer.
Replacing the battery
The PCRTC uses a lithium AA 3.6V battery to maintain its
clock while the host computer is off. Replacement batteries must be
rated between 3 and 4 volts. Batteries can be ordered through B&B
as part number 3345. After replacing the battery, the PCRTC needs
to be reinitialized. If the device driver loads in your config.sys file,
the card will automatically be initialized, otherwise, the command
line option PCRTC {address} /I can be used. After replacing the
battery, the time and date must be reset.
Programming with the PCRTC
If you are writing your own application, you may wish to
access the status features of the PCRTC in addition to accurate
timekeeping. An “include” file for C, Pascal, and QuickBASIC is
provided to allow simple function calls to check battery status
and the time of last power down or reset. Sample programs
demonstrating how to make these calls are provided in each of the
three languages. The device driver keeps the DOS clock updated to
the correct time, so accurate time can be obtained using the
standard DOS calls.