BLACKHAWK! BH6034 - Manual (Page 5)

5
2. Slowly turn the handle counterclockwise, but no more than 1/2 turn.
If the load fails to lower:
a. Use another jack to raise the vehicle high enough to reinstall jack stands.
b. Remove the malfunctioning jack and then the stands.
c. Using the functioning jack, lower the load by turning the operating handle counterclockwise, but no more than
MAINTENANCE
Important: Use only a good grade hydraulic jack oil. Avoid mixing different types of fluid and Never use brake fluid,
turbine oil, transmission fluid, motor oil or glycerin. Improper fluid can cause failure of the jack and the potential for
sudden and immediate loss of load. We recommend Hein-Werner HW93291 hydraulic oil or equivalent.
Adding oil
1. With saddle fully lowered set jack in its upright, level position. Locate and remove oil filler plug.
2. Fill with oil until ~3/16" above the inner cylinder as seen from the oil filler plug hole. Reinstall the oil filler plug.
Changing oil
For best performance and longest life, replace the complete fluid supply at least once per year.
1. With saddle fully lowered, remove the oil filler plug.
2. Lay the jack on its side and drain the fluid into a suitable container.
Note: Dispose of hydraulic fluid in accordance with local regulations.
3. Fill with oil until ~3/16" above the inner cylinder as seen from the oil filler plug hole. Reinstall the oil filler plug.
Lubrication
A coating of light lubricating oil to pivot points, axles and hinges will help to prevent rust and assure that wheels,
casters and pump assemblies move freely.
Cleaning
Periodically check the pump piston and ram for signs of rust or corrosion. Clean as needed and wipe with an oily
cloth.
Note: Never use sandpaper or abrasive material on these surfaces !
Storage
When not in use, store the jack with saddle fully lowered.
• Leer, comprender, y seguir las instrucciónes
antes de utilizar el aparato.
• El manual de instrucciónes y la información de
seguridad deben estar comunicado en lengua del
operador antes del uso.
• No seguir estas indicaciónes puede causar daños
personales o materiales.
! ADVERTENCIA
Be sure all tools and personnel are clear before
lowering load. Only attachments and/or adapters
supplied by the manufacturer shall be used. Lift
only on areas of the vehicle as specified by the
vehicle manufacturer.
! Safety Messages !
1/2 turn.