Instruction for use – Bodum 11445 User Manual
Page 4
INSTRUCTION FOR USE
3
–
Scalding may occur if the lid is removed during the brew-
ing cycles.
–
If the kettle is overfilled, boiling water may be ejected.
–
Do never boil water without the lid on.
–
Always ensure that you pour out boiling water slowly and
carefully, taking care not to tilt the spout too rapidly.
–
To prevent scalding, avoid coming into contact with the
steam escaping from the opening in the lid when the
water is being boiled or just after the kettle has switched
off. Be careful when opening the lid, if the kettle is still
hot and you wish to refill it with water.
–
Boiling water can cause burns.
–
Move the appliance with extreme care when it contains
hot water.
–
Do not forcefully locate the switch in the ON position, or
make any authorised changes to the switch in order to
make it stay in the ON position. This could lead to steam
escaping from around the lid, damaging the automatic
switch-off mechanism and possibly causing bodily injury.
–
Never immerse the item in water, remember this is an
electrical appliance.
–
Only clean the appliance using a damp cloth.
–
To disconnect, turn any control to «off» then remove plug
from wall outlet.
–
Always unplug the appliance by holding the plug, not the
cord.
–
Do not let cord hang over edge of table or counter, or
touch hot surfaces.
–
Unplug the power cord from the wall outlet when the
kettle is not in use and before cleaning. Allow the kettle to
cool before putting on or taking off parts and cleaning it.
–
Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions, or has been
damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or
adjustment.
–
Never attempt to exchange the mains cable of the
appliance as special tools are required for this. To ensure
continued safety of the appliance, if the cable needs
to be repaired or exchanged, have this carried out
exclusively by a customer service workshop authorised by
the manufacturer.
–
To protect against fire, electric shock and injury to
persons do not immerse cord, plug, kettle container and
power base in water or other liquid.