Barco MATRIXPRO-II 3G/HD/SD-SD - Manual (Page 18)

MatrixPRO-II 3G/HD/SD-SDI Routers Rev. 1.1
MatrixPRO-II HD/3G SDI Series –User’s Guide - Rev. 1.1
18
Layer 2 Input Layer 2 Output
1 9 1 9
2 10 2 10
… … … …
8 16 8 16
Layer 3 Input Layer 3 Output
1 17 1 17
2 18 2 18
… … … …
8 24 8 24
Layer 4 Input Layer 4 Output
1 25 1 25
2 26 2 26
… … … …
8 32 8 32
3.3 SW7: Power alarm
The power alarm can be switched according to the following pattern:
SW 7 Power alarm
OFF Disables Power Alarm
ON Enables Power Alarm
Default setting is Power Alarm disabled.
Changing this from default setting should only be done when using two
(redundant) power supplies.
3.4 SW8: Power-up mode
Switch 8 on the configuration switch defines the power up mode on NxN square routers. The
MatrixPRO-II router provides two modes for powering up the system.
The power up options can be switched according to the following pattern:
SW 8 Power Up mode
OFF Switches all outputs according to the buffered information in the
routers processor system.
ON Switches all outputs to input 1.
Default setting switches all outputs according to the buffered information in the routers
processor system.