Bissell 2810 - Manual (Page 5)

5
Assemble the Handle by screwing together two pieces
of the Metal Extension Handle. Place the colored Handle
Grip on top of the metal extension assembly and twist
clockwise until secure. Screw the Handle Clip into the
bottom of the Metal Extension Handle assembly.
Place bottom of Handle Clip into the opening at the top
of the Perfect Sweep TURBO. Push firmly until the button
at the bottom “clicks” into place in the opening.
The Perfect Sweep TURBO must be fully charged before
using. To charge the unit, plug the DC Adapter into a
standard electrical outlet (120v-60hz); plug the opposite
end into the Charging Port on the back side of your Perfect
Sweep TURBO. The Charging Indicator Light will illuminate
when properly connected and will not turn off when fully
charged. The Perfect Sweep TURBO is now charging.
Note: The Power Switch must be in the OFF
position when charging.
When completely charged, the Perfect Sweep TURBO
provides up to 60 minutes of full cleaning power.
When charging for the first time, allow to charge uninterrupted
for at least 16 hours. Thereafter, charge at least 12 hours to
renew the Perfect Sweep TURBO battery.
Note: The Power Switch must be in the OFF
position when charging.
Decreased operating time may indicate the battery has
built up a charging resistance. To recharge, first completely
exhaust the battery, recharge it, then exhaust it again before
recharging a second time. This procedure may be required
more than once.
When charging is complete, be sure to unplug the
Perfect Sweep TURBO from the charger.
If your battery still fails to recharge or does not hold a charge of
normal duration, call:
BISSELL Consumer Services
1-800-263-2535
Monday - Friday 8 a.m. — 10 p.m. ET
Saturday 9 a.m. — 8 p.m. ET
Or visit our website @
www.bissell.com
1.
2.
3.
Quick and Easy Assembly
Plug into Charging Port
on the Motor side of the
Perfect Sweep Turbo.
Charging Cord with
DC Adapter Plug
Charging the Battery
1.
2.
3.
4.