Behringer FCB1010 - Manual (Page 12)

MIDI FOOT CONTROLLER FCB1010
12
Fig. 2.5: Sending a SysEx-Dump
2.7.2 Receiving SysEx dumps
To send back FCB1010 data stored on a sequencer/computer
before, please follow the instructions below:
s
Connect the MIDI OUT connector of your sequencer or
computer to the MIDI IN connector of the FCB1010
(see fig. 2.6).
s Keep the DOWN switch pressed during power-up to enter
the GLOBAL CONFIGURATION menu.
s Press UP until the CONFIGURATION LED lights up. Now the
unit is in CONFIGURATION mode.
s Press footswitch #7 (SYSEX RCV) to “tell” the FCB1010 to
wait for system-exclusive data (the footswitch LED lights
up). Start the PLAYBACK function on your sequencer/
computer to play back the previously stored file. The foot-
switch LED flashes while the FCB1010 is receiving data.
Once the data have been received correctly, the LED dies
out. Now your programs are back in the FCB1010’s memory.
Quit GLOBAL CONFIGURATION mode by means of a long
press on DOWN.
Fig. 2.6: Receiving a SysEx dump
2.8 Restoring factory presets
This function allows you to restore factory defaults of your
FCB1010.
+
In doing so, all preset settings made by you are
overwritten!
Resetting your FCB1010 lets you restore various default
settings that are optimized for use with BEHRINGER audio
equipment. This is why there are three different key combinations
that let you reload the desired defaults into the memory of your
FCB1010. This key combinations are shown in table 2.5:
Tv‡pu 9rshˆy‡Ã†r‡‡vtГs‚ Г
1 + 6 V-AMP family products
1 + 7 BEHRINGER guitar amps
1 + 8 BASS V-AMP product range
Tab. 2.5: Reset key combinations
Keep the respective footswitches pressed for roughly 2.5
sec while powering up your FCB1010. The displays reads “09”
to “00” and the points are blinking. When the points are no longer
shown, your FCB1010 has been reset to factory defaults and is
ready for operation.
2.9 Calibrating expression pedals A and B
Should you experience problems with exact MIDI controller
data transmission while using the expression pedals, we
recommend calibrating the pedals. Calibrating the pedals follows
the complition of the FCB1010 self-test.
+
All software versions 1.4 and newer allow for direct
calibration by keeping the switches 1 and 5 pressed
while powering up the unit. If your FCB1010 features
the software version 1.4 or higher, skip the first 4
steps in the set of instructions that follow (i.e. start
at point number 5). To find if your unit features
version 1.4 or higher of the software, first try
keeping the switches 1 and 5 pressed while
powering up the unit. If nothing happens, start
calibrating your FCB1010 beginning with the first
step in the list that follows.
2. PROGRAMMING THE FCB1010