Philips DailyDuo Aspirador de escoba - Manual (Page 11)

5 Clean the inner filter and the outer filter with a brush or with a standard vacuum cleaner if
they are very dirty.
Note: If necessary you can clean the inner filter and the outer filter in cold or lukewarm water. Dry the
inner and outer filter thoroughly before you use the filter unit again.
6 Place the inner filter back onto the filter holder (1) and turn it anticlockwise to attach it
(2). (Fig. 24)
7 Place the outer filter back onto the filter holder (1) and turn it anticlockwise to attach it
(2). (Fig. 25)
8 Put the filter unit back into the dust compartment (Fig. 26).
Note: Make sure you insert the filter unit in the correct way. The word ‘up’ must point towards the top of
the dust compartment.
9 To reattach the dust compartment, align the slot on the dust compartment with the
projection on the handheld vacuum cleaner. First attach the bottom of the dust compartment
(1) and then push the top of the dust compartment towards the vacuum cleaner (2) until it
locks into place (‘click’). (Fig. 20)
Cleaning the floor nozzle joint
The joint of the floor nozzle may get blocked by large dirt particles. Follow the steps below to clean
the joint.
1 Press the on/off button on the stick to switch off the appliance.
2 Press the handheld vacuum cleaner release button (1) and remove the handheld vacuum
cleaner from the stick (2) (Fig. 11).
3 Press the floor nozzle release button (1) to detach the stick from the floor nozzle
(2) (Fig. 27).
4 Remove the large dirt particles from the joint.
5 Place the stick back onto the floor nozzle (‘click’).
Cleaning the roller brush
When the ‘brush blocked’ light starts to flash red, the roller brush is blocked. If this happens, follow
the steps below to clean the roller brush.
1 Press the on/off button on the stick to switch off the appliance.
2 Press the handheld vacuum cleaner release button (1) and remove the handheld vacuum
cleaner from the stick (2) (Fig. 11).
3 Press the floor nozzle release button (1) to detach the stick from the floor nozzle (2).
4 Turn the floor nozzle upside down.
5 Move the roller brush until the cutting groove faces you. (Fig. 28)
6 Use a pair of scissors to cut the hairs, threads etc. that have collected around the roller
brush. (Fig. 29)
7 Remove fluff, hairs and other dirt from the roller brush.
Note: You can also remove the roller brush for easier cleaning.
English 11