Maintenance, Warning – Briggs & Stratton 350000 User Manual

Page 11

Advertising
background image

Document: - page 11 (Black)
Screen angle and frequency: 45.0000, 150.0000

11

MAINTENANCE

MAINTENANCE

Regular maintenance will improve the performance and
extend the life of the engine. See any Authorized Briggs &
Stratton Dealer for service. Use only genuine Briggs &
Stratton parts. Other parts may not perform as well,
may damage the engine, and may result in injury.
In
addition, use of other parts may void your warranty.

EMISSION CONTROL

Maintenance, replacement or repair of the emission
control devices and systems may be performed by any
nonroad engine repair establishment or individual.
However, to obtain no charge repairs under the terms and
provisions of the Briggs & Stratton warranty statement, any
service or emission control part repair or replacement must
be performed by a factory authorized dealer.

Follow the instructions and schedules indicated below.

Task

Perform task at hourly

or calendar interval,

whichever comes first.

Every 8 Hours

or Daily

25 Hours or

Every Season

50 Hours or

Every Season

100 Hours or

Every Season

Y

early

Check oil level

4

Change oil

4

*

Change oil filter
(if equipped)

4

Service air cleaner
pre-cleaner

4

**

Service air cleaner
cartridge

4

**

Inspect spark arrester
(if equipped)

4

Clean oil cooler
(if equipped)

4

**

Clean cooling system

4

**

Clean/replace
spark plugs

4

Clean/replace in-line
fuel filter (if equipped)

4

Check valve clearance

4

*

Change oil after first 5 to 8 hours of use, then every
50 hours or every season. Change oil every 25 hours
when operating the engine under heavy load or in high
temperatures.

** Clean more often under dusty conditions or when

airborne debris is present. Replace air cleaner parts, if
very dirty.

CAUTION: Used oil is a hazardous waste product.
Dispose of used oil properly. Do not discard with
household waste. Check with your local authorities,
service center, or dealer for safe disposal/recycling
facilities.

CHANGING OIL

WARNING

[1]

Place engine level.

[2]

Disconnect spark plug
wires and keep away
from spark plugs. Dis-
connect battery (if equip-
ped with electric starter)
at negative terminal.

OIL DRAIN

PLUG

Typical

drain plug

PIPE

[3]

With engine OFF but still warm remove oil drain
plug and drain oil into appropriate receptacle.

[4]

Reinstall drain plug. Remove dipstick.

[5]

Oil filling procedure: first add 1 quart (32 ounces
or 1 liter). Start and run engine at idle for 30
seconds. Shut engine off and wait 30 seconds.
Then add more oil slowly to bring level to Full mark
on dipstick.

[6]

Fill to FULL mark on dipstick with new oil.
Do not overfill.

Note: Engine holds approximately 1-1/2 quarts
(48 ounces or 1.4 liters) when changing oil and filter.

[7]

Replace dipstick.

Advertising
This manual is related to the following products: