Babies "R"Us 1926032H11 - Manual (Page 8)

NOTE : If you are not able to tighten the mounting assembly enough,
be sure to re-check the straps to see that they are not twisted. Once you
have checked, flip the locking tab to the open position and give the
mounting strap a good pull to snug it up. Be sure to lock the tab again
by pressing it into the closed position.
Step 6 : Repeat the previous steps for the right side of the bed rail assembly.
Once mounted, the assembly should look like the photo below.
(Diagram E1)
Step 5 : Proper tightening and adjustment- locate the locking tab on the Left
Receiver Assembly. Make sure it is in the open position.
(Diagram D1) With tab in
the open position, pull the anchor strap until the bed rail mounting assembly is
tight up against the mattress. When the strap is snug, be sure to close the locking
tab to secure the strap.
(Diagram D2)
(Diagram D1) (Diagram D2)
(Diagram E1)
7