Broilmaster BRB-1 - Manual (Page 21)

Page 21 B101502-1-0311
BDA D
OUBLE
D
OOR
I
NSTALLATION
FIGURE 6
1
Remove doors from frames by depressing one of the
spring loaded pins on each door and set them aside.
Disassemble frame by removing the two screws and
door pin from both door frames as shown in FIGURE
5.
27 ½”
19 13/16”
Use the door brackets included in the hardware
packages to combine the frames. Use the screws from
the single door to attach the bracket, and place the
door pin in position. FIGURE 6
2
Make sure BDA Double Door opening dimensions
match those in FIGURE 7. Place the Frame into
the opening and check for proper hole alignment.
Secure the Frame to the enclosure with 2 screws.
FIGURE 7.
Secure the Doors to the door frame by inserting the
spring loaded pins in the bottom frame holes. Locate
the upper hole in the BDA frame and push on the spring
loaded pin on the door and insert it into the frame.
Figure 4.
Make sure the Door is Aligned and Secured prop-
erly by opening and closing door.
3
NOTE: You will need two BDA door kits for this installation.
FIGURE 5
FIGURE 7