Barco R5976924 User Manual
Projector toolset
Advertising
Table of contents
Document Outline
- toc
- 1. Basic concepts
- 2. Installation
- 3. Menus
- 4. Preferences
- 5. Configurator
- 5.1 Introduction
- 5.2 Configurator window
- 5.3 Create a new configuration
- 5.4 Add projector to a configuration
- 5.5 Reconnect a projector
- 5.6 Move projector to a group
- 5.7 Edit projector properties
- 5.8 Configuration preview
- 5.9 Configuration properties
- 5.10 Preview layout properties
- 5.11 Multiple projector selection
- 6. Configurator, General projector settings
- 7. Configurator, Projector alignment settings
- 8. Configurator, Projector adjustment settings
- 8.1 Native resolution
- 8.2 Window and Source selection
- 8.3 Configuring an input slot
- 8.4 Status input window, visible - not visible
- 8.5 Input files
- 8.5.1 Introduction
- 8.5.2 Loading a fitting input file
- 8.5.3 Load a file from all files
- 8.5.4 Edit Input settings
- 8.5.5 Save changes on an input file
- 8.5.6 Rename the current input file
- 8.5.7 Deleting an input file
- 8.5.8 Aspect ratio for selected input
- 8.5.9 Input balance
- 8.5.10 Input color temperature
- 8.6 Image settings
- 8.7 Layout settings
- 8.7.1 General introduction
- 8.7.2 Load a layout
- 8.7.3 Show window border
- 8.7.4 Re-size a layout window
- 8.7.5 Move a layout window
- 8.7.6 Aspect ratio output window
- 8.7.7 Lock a input window
- 8.7.8 Set input window to full size
- 8.7.9 Save a layout
- 8.7.10 Layout Save as
- 8.7.11 Rename a layout
- 8.7.12 Delete a layout
- 8.7.13 Edit window texture
- 9. Configurator, Color alignment
- 10. Configurator, Installation settings
- 11. Configurator, Communication settings
- 12. Configurator, Warping
- 13. Configurator, Warp User Interface
- 13.1 About the Warp UI
- 13.2 About the Floater menu
- 13.3 Increasing - decreasing the number of nodes
- 13.4 Make node selection
- 13.5 Change selection to new active node
- 13.6 Making an adjustment via drag and drop
- 13.7 Making an adjustment via the Floater menu or keyboard
- 13.8 Add a hard edge
- 13.9 Move a hard edge line
- 13.10 Remove a hard edge
- 13.11 Show hard edge in active node mode
- 13.12 Save configuration to file
- 13.13 Load a configuration in the Warp UI
- 13.14 Start up cylindrical warping
- 13.15 Indentation
- 13.16 Gradient
- 13.17 Fast preview
- 13.18 Re-size and centering for cylindrical warping
- 13.19 Recover warping board
- 13.20 Preferences
- 14. Update module
- 15. Diagnostics module
- 16. Lens calculator
- 17. Service module