Bosch 8-Dec - Manual (Page 420)

412 | Conettix - Information Transport Solutions | Conettix IP
Conettix C900V2 Dialer
Capture Ethernet Module
Features
▶ Captures alarm and event data from dialer-based
control panels using CONTACT ID, SIA, Modem II,
Modem IIe, Modem IIIa
2 , Pulse, and other formats
▶ Performs full data transmissions without changing the
data
▶ 12 VDC to 24 VDC voltage range
▶ Re-routes signals using UDP/IP-based data networks
▶ Convenient connection (RJ-45 Jack) to Ethernet
networks
▶ Integrated 10/100 Network Interface Module (NIM)
▶ Provides acknowledgement from the receiver to the
control panel
▶ Supports 128-bit AES Rijndael encryption
The Conettix C900V2 Dialer Capture Ethernet Module
works with most control panels using a standard digital
dialer format and provides end-to-end security. The module
links the digital dialer to the Public Switched Telephone
Network (PSTN), the digital dialer’s telephone interface,
and an Ethernet network. With the Ethernet link, the
C900V2 can:
• Communicate with the control panel dialer
•
Decode and deliver signals to a Conettix D6600
Communications Receiver/Gateway
• Relay a confirmation message back to the control panel
dialer
Whether a control panel dials through a telephone line or
through the C900V2, the data remains the same. The
C900V2 empowers digital dialer control panels to work over
an IP network such as a Local Area Network (LAN), a Wide
Area Network (WAN), or the Internet.
System Overview
When the dialer has a message to report, the C900V2
simulates dial tone and line voltages, causing the dialer to
behave as though it is connected to a monitoring center
digital receiver through the PSTN. The C900V2 decodes and
converts the transmitted dialer message to data for
transport over any UDP/IP network.
After the Conettix D6600 Communications Receiver/
Gateway receives a message or event, it sends an
acknowledgement message to the C900V2. The C900V2
returns an appropriate response to the dialer, maintaining
end-to-end acknowledgment.
The C900V2 operates in Intercept Mode, connecting the
dialer to the network under normal circumstances. If the
C900V2 loses contact with the Conettix D6600
Communications Receiver/Gateway, the unit goes into
Fallback Mode, connecting the dialer to the PSTN telephone
line.
1. Control Panel
2. Dialer Connection
2.1 Dialer Output to RJ-31x Jack and PSTN
3. Conettix C900V2 Dialer Capture Ethernet Module
4. Ethernet or LAN Connection
5. LAN, WAN, or the Internet
6. Connection To Ethernet Network Interface Card (NIC)
7. Host PC with Conettix D6200 Programming/Administration Software
8. Conettix D6680 Ethernet Network Adapter
9. Com 1 (Optional)
10. Com 4
11. Conettix D6600 Communications Receiver/Gateway
Bosch Security Systems B.V. www.boschsecurity.com
7