Baby Trend SNAP N GO 1305 - Manual (Page 3)

ASSEMBLY:
• Remove stroller from box. The front wheels, rear wheels and
parent tray need to be installed prior to use.
• To attach the front wheels, unfold stroller as described in the
section following. See figure 1. Lean the stroller backwards so
that it rests on the handle and rear frame tubes and the front wheel
bayonet are pointing upward. Position the front wheel assembly
at the front wheel bayonet such that the swivel assembly will slide
onto the front wheel bayonet. Push each front wheel assembly
onto the front wheel bayonet until snapped into place. Pull on
the wheel assembly to ensure that it is securely attached to the
stroller. Please see figure 2.
• Lean the stroller forward to rest on the front wheels. To attach
the rear wheels, position the rear axle and wheel assembly such
that the brake levers are facing to the rear of the stroller. Press the
rear wheel assembly onto the rear frame tubes being careful that
the push buttons on the forward side of each rear tube engage the
hole on the forward side of each rear wheel housing. Pull on the
rear wheel assembly to ensure that it is securely attached to the
stroller. Please see figure 3.
Ensure that the wheels are firmly locked into place. Do Not use the
stroller if the wheels are not locked into place, but rather contact
our customer service department immediately at 1-800-328-7363,
between the hours of 8:00am and 4:30pm PST, for assistance.
BASKET
Rear basket tube needs to be installed prior to use. Insert the
female end of the rear basket tube into the male ends located on the
basket frame until it locks into place. (Fig. A)
TO ENSURE SAFE OPERATION OF YOUR STROLLER, PLEASE FOLLOW
THESE INSTRUCTIONS CAREFULLY. RETAIN THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
Stroller
Front Wheels
Rear Axle
Parent Tray
Figure 1.
Figure 2.
Figure 3.
Push onto
bayonet
2
Rear basket tube
Basket frame
Figure A