Baby Trend Nursery Center PY81988 - Manual (Page 3)

Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved. Copyright © 2009 - 2010, Baby Trend Inc., All Rights Reserved.
PARTS
TO ASSEMBLE PLAYARD
ATTENTION:
Playard must be fully assembled and securely
locked before installing or using other accessories.
1. Unzip bag and remove Playard frame (Fig. 1).
Undo the three (3) Fasten straps and set the
Mattress aside.
2. DO NOT push center down yet.
3. Top rails must be fully erected before lowering
center. Pull up one rail at a time, hold one hand
on each side of the rail and pull up sharply, do
not pull from the middle where the center latch
release is located, make sure both tubes latch in
place and each rail is rigid. (Fig. 2).
IMPORTANT: The center must be raised
while locking the rails. If one rail will lock
but the other side will not then, unlock the rail
by squeezing the release in the center and try
again.
4. Once all four (4) top rails are locked in place,
push down on the center handle (Fig. 3). The
center mechanism will rotate clockwise 90
degrees and automatically lock in place.
ASSEMBLY
3 4
IMPORTANT!
To ensure safe operation of your playard,
please follow these instructions carefully. Please keep these
instructions for future reference.
IMPORTANT!
Before assembly and each use, inspect this
product for damaged hardware, loose joints, missing parts or sharp
edges. NEVER use if any parts are mssing or broken.
IMPORTANT!
Adult assembly is required.
Fig. 1
Fig. 2
Playard
Mattress
Fig. 3
Playard
Mattress
Bassinet
Travel / Storage Bag
Check the parts list on the back cover to make sure you have
all the parts for this model before assembling the playard.
Fixed Mobile*
*Toy type vary
Metal Support Tubes
(2 male, 2 female)
Diaper Stacker