Baby Trend Jogger Travel System 9139CT - Manual (Page 6)

Fig.18
Fig 17.
STRANGULATION HAZARD:
Child can strangle in loose straps. Never
leave child in seat when straps are loose or
undone.
* To release, apply pressure to both sides of each male clip until the
clip is released. See Figure 15. This process requires a moderate
amount of effort so as to prevent an accidental release by your
child.
SEATBACK POSITIONING
* The seat has a multiple position recline that is controlled by a strap
and buckle assembly behind the seat. See figure 16. To recline the
seat, loosen the strap through the buckle and adjust to the required
recline position. Please see figure 17. To place the seat back in the
upright position, press upward on the seat back with one hand while
pulling the strap through the buckle with the other. The strap will
lock automatically.
ATTACHMENT OF THE BABY TREND INFANT CAR SEAT
* To attach the Baby Trend Infant Car Seat, recline the seat all the way
back. See figure 18.
* Check that the front child tray is firmly attached to the stroller
armrests.
Make sure that the car seat locks into the front child tray.
Then turn tabs on stroller frame to lock the front of the car seat into the
stroller. See figure 19.
* Position the Infant Car Seat, facing toward the rear of the stroller,
so that the seat shell goes into the front tray and latches into place.
Please see figure 20.
Check that the Infant Car Seat is firmly locked onto the front
tray before using.
* To remove the Infant Car Seat, turn the tags, squeeze the release
handle located at the foot-end of the seat and carefully lift upward on
the seat. Please see figure 21.
5
Fig 16.
Fig.21
Fig.15
Fig.19
Fig.20
Locks into tray