Britax FRONTIER 85 SICT - Manual (Page 17)

30 31
1 Rotate the recline block to the
front and place the child seat
on the vehicle seat.
* Ensure harness height is
adjusted to fit your child.
2 Pull the vehicle belt out and
route the belt through the first
belt slot, under the cover and
through the second belt slot.
3 Verify that the belt is not
twisted, then buckle.
4 Push the child seat firmly
into the vehicle seat while
removing all slack from the
vehicle belt.
* Ensure that the vehicle belt
is locked as directed by your
vehicle owner’s manual.
* The child seat is secure when it
cannot be moved front-to-back
or side-to-side more than 1 in.
(2.5 cm) at the belt path. If the
child seat is not secure, repeat
the installation procedure or
use a different seating location.
5 Firmly press the Versa-Tether
hook to the vehicle tether
anchor to attach. Remove all
slack from the tether webbing.
6 Use the elastic strap to contain
extra webbing.
2 3
OR
OR
Checklist
9 Check that positioning block is rotated to the front.
9 Check all connections and verify that child seat is secure.
* The child seat is secure when it cannot be moved front-to-
back or side-to-side more than 1 in. (2.5 cm) at the belt path.
If the child seat is not secure, repeat the installation procedure
or use a different seating location.
9 Ensure any excess Versa-Tether ® webbing is stored in elastic
band. Always ensure any excess webbing is contained within
your vehicle.
This seat may only be used in booster mode with children who
stand 42 – 65 in. (106.7 – 165.1 cm) in height and weigh more than
40 lbs (18.1 kg). Britax recommends booster mode only after the
child outgrows harness mode.
Harness to Booster Mode
To remove the harness and buckle:
1 Loosen the harness.
a Press release lever
b Pull both harness straps forward
2 Remove the belt shield and
unhook the harness straps from
the yoke.
3 Replace the belt shield (a) then
store the yoke in the slot (b).
4 Pull the harness straps out of
the slots.
* DO NOT remove the HUGS™
chest pads or chest clip.
5 On the bottom of the seat,
slide the retainer of one
harness strap up and pull it
away from the child seat shell.
Installing the Child Seat: Harness Mode Switching Between Modes