Operating cont’d, Operating your espresso/cappuccino machine – Breville ESP6/8 User Manual

Page 4

Advertising
background image

BEFORE USING YOUR
ESPRESSO MACHINE

Wash the filter holder and the stainless

filters in mild detergent and water.

Rinse thoroughly.

FILLING THE WATER TANK

Ensure the Power switch and Selector

Control are set to the ‘OFF’ position.

Turn off at the power outlet and unplug

the power cord.

Lift up the water tank lid and remove the

water tank. Fill with cold water to the

maximum mark and replace in the

machine, pressing down firmly so that the

water valve opens. Close the water tank lid.

PRE-HEATING THE MACHINE

For optimal crema, it is recommended to

carry out a complete brewing operation with

water but without any coffee grinds before

making your first coffee to ensure that the

machine has been preheated.

Make sure the selector control is in the

‘OFF’ position.

Plug the power cord into a 230/240V

electrical outlet, switch on and set the

power switch to the ‘ON’ position.

As soon as the orange ‘heating’ light

turns off, set the selector control to the

‘ESPRESSO’ position and run a small

amount of water through the brewing

head for a few seconds without the filter

holder in place.

PRE-WARMING CUPS

For optimal coffee temperature, pre-warm

the espresso cups by placing them on the

cup warming plate.

6

PREPARING THE COFFEE

Place the 1 or 2 cup filter into the filter

holder and fill with espresso coffee (use

the smaller filter for 1 cup and the larger

filter for 2 cups).

Use 1 level measure of espresso coffee

for the 1 cup filter and 2 level measures

for the 2 cup filter. It is important to use

the correct amount of coffee as the filter

perforations have been constructed for

optimal pressure build up in the machine.

Distribute the coffee evenly and press it

lightly with the bottom of the measuring

spoon (if there is too much coffee, the

flow of water can become blocked).

Clean any excess coffee from the rim of

the filter holder to ensure a proper fit

under the brew head.

Place the filter retainer clip in the release

position, by pulling the clip back towards

your hand.

Place the filter holder underneath the

brew head so that the handle is positioned

to the left of centre. Lift the filter holder

until it contacts the brew head and rotate

to the right.

OPERATING cont’d

7

OPERATING YOUR ESPRESSO/CAPPUCCINO MACHINE

• The water tank should

be filled with fresh cold

water before use

• Check water level before

use and replace the

water daily

• Do not use mineral or

distilled water

Advertising