B&B Electronics Parallel Port Input/Output Converter PPIO - Manual (Page 5)

PPIO2899 Manual
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104
3
PC P
ARALLEL
P
ORT
D
ESCRIPTION
To understand how the PPIO can be controlled you must
first understand how the parallel port works inside the computer. The
parallel port is designed to connect the computer with the outside
world. It can have up to 12 TTL compatible outputs and up to 9 TTL
compatible inputs. It cannot have both at the same time since some
inputs and outputs share pins. Eight of the outputs and five of the
inputs are dedicated. Four of the lines can be either inputs or
outputs.
The main use for the parallel port is to send data to a
printer. The port uses the eight dedicated outputs for data and the
other lines for handshakes. Under normal printer operation, the
computer will put an eight-bit byte on the eight lines (pins 2-9) and
then use the Strobe output (pin 1) to tell the printer to read the data.
Upon receipt of an Acknowledge (pin 10) from the printer the
computer knows that the eight bit word was received. It can then
send the next word. Other lines are used for busy, off line, etc.
All the control of the parallel port is done through software. If
you look at the hardware you find that the parallel port is connected
directly to the computer bus. This means that we can address these
inputs and outputs in any way we want if we do not use the port to
drive a printer.
Each PC has port addresses where the parallel ports, serial
ports, hard disk, etc. can be addressed. These are located in the
address range from 0000H to 03FFH (the H indicates the use of the
hexadecimal numbering system). Each parallel port has one main
port address for outputting data. The next two addresses above that
address are used for handshaking control. For instance, on a typical
computer a parallel port could be located at address 0378H. The
handshaking lines will then be located at 0379H and 037AH. Table 1
shows the correspondence between the bits of the port and the pins
of the DB-25 female connector.
Referring to Table 1, if you output a 01H (which is 00000001
in binary) to your computer’s port 0378H, then pin 2 of the parallel
port’s DB-25 connector will be HIGH and pins 3 through 9 will be
LOW. To do this using GWBASIC you would use the command:
OUT &H378,&H01. Using this method you can output any pattern
you wish on pins 2 through 9 of the parallel port. To turn ON pins 2,
4, 6, and 8 use: OUT &H378,&H55. 55H is the same as 01010101
binary. This port (0378H) can be read as an input, but mostly it is