Braun 5281 - Manual (Page 2)

2 3
English
Our products are engineered to meet
the highest standards of quality,
functionality and design. We hope you
thoroughly enjoy your new Braun
appliance.
Braun exact 6 memory universal
This appliance can be operated on all
international alternating current
outlets. Its built-in rechargeable cell
permits 2-way beard trimming: either
with the cord connected directly to an
outlet (cord operation) or without the
cord via the rechargeable cell
(cordless operation).
Specifications
Voltage range: 100 - 240 V (~)
50 - 60 Hz
Wattage: 3.5 W
Trimming system: cutting unit 3 ,
trimming width 34 mm,
distancing comb
4 for 6 beard length
settings (2, 5, 8,11,14,18 mm)
Memory function
Charging time: 2 hours
Quick charge for one trim: 10 minutes
Operating time: approx. 60 minutes
(fully charged)
The best environmental temperature
range for the trimmer is between
15 °C - 35 °C. The trimmer should
never be exposed to temperatures of
less than 0 °C and more than 40 °C for
longer than a few hours.
Do not wind the cord around the
appliance.
Environmentally friendly cell unit
For environmenfal reasons, this
appliance is provided with a nickel-
hydrid cell unit. This cell unit does not
contain any poisonous heavy metals.
Nevertheless, in the interest of
recycling raw materials please
do not dispose of this appli-
ance in the household waste at
the end of its useful life.
Disposal can take place at a Braun
Service Centre or at appropriate
collection sites.
Description
1 Pilot light
2 Switch (on/off), cutting lenght)
3 Cutting unit
4 Distancing comb
5 Memory-Switch
6 Cleaning brush
Cord operation
The trimmer is ready for use
immediately via cord operation (i.e.
when the trimmer is connected
directly to an electrical outlet).
lf the trimmer should, however, not run
immediately due to a completely
empty cell, recharge the trimmer for
approx. 1 minute (switch turned off =
«0»), which is sufficient to permit
trimming via cord operation (after
turning the switch on again).
Cordless operation
Turn the trimmer off (switch 2 set to
«0»), connect the cord to the trimmer
and plug into an electrical outlet.
Recharge for 5 hours. The pilot light
1
is illuminated at the beginning of the
charging process and changes to
flashing as the appliance is being
charged, with increasingly longer
pauses. When recharged, unplug the
trimmer. The trimmer should not stay
connected to an outlet for several
weeks. Occasional overcharging for
several days will, however, not
damage the trimmer.