Philips Centrale vapeur haute pression User Manual
Page 9
Note: During steam ironing, the temperature light goes on from time to time. This indicates that the iron
is heating up to the set temperature.
Note: If you have been ironing at a high temperature and then set the temperature dial to a lower
setting, wait until the temperature light goes on and goes out again before you continue ironing. This
prevents damage to your fabrics.
tips
- If the fabric consists of various kinds of fibres, always select the temperature required by the
most delicate fibre, i.e. the lowest temperature. For example: if an article consists of 60%
polyester and 40% cotton, it should be ironed at the temperature indicated for polyester ( 1)
and without steam.
- When you steam iron woollen fabrics, shiny patches may occur. To prevent this, use a dry
pressing cloth or turn the article inside out and iron the reverse side.
- Iron velvet and other fabrics that tend to acquire shiny patches in one direction only (along with
the nap) while you apply very little pressure.
- Do not use steam when you iron coloured silk. This could cause stains.
using the appliance
Steam ironing
1
Make sure that there is enough water in the steam tank.
2
Set the required ironing temperature (see chapter ‘Preparing for use’).
Note: Steam ironing is only possible at higher ironing temperatures (temperature settings 2 to MAX).
3
Put the mains plug in an earthed wall socket and set the on/off switch to ‘I’.
- The power-on light in the on/off switch and the temperature light on the iron go on to indicate
that the steam tank and the iron start to heat up.
4
GC6540: Select a steam setting suitable for the selected ironing temperature: (Fig. 7)
- Select steam setting ECO for temperature setting 2.
- Select a steam setting between ECO and ; for temperature settings 3 to MAX.
5
The steam tank and the soleplate heat up.
- Cold start: the soleplate takes approximately 2 minutes to heat up and the steam tank takes
approximately 6 minutes to heat up.
- Quick reheat: if you refill the steam tank during the ironing process, the water in the steam
tank takes approximately 6 minutes to heat up.
, When the iron has reached the set temperature, the temperature light goes out.
, As soon as the water in the steam tank is ready for steam ironing:
- GC6540: the ‘steam ready’ light goes on (Fig. 8).
Note: During steam ironing, the ‘steam ready’ light goes out from time to time. This indicates that the
steam tank is heating up to the right temperature.
- GC6530/GC6520/GC6515/GC6510: the power-on light in the on/off switch goes out.
6
Press the steam trigger and keep it pressed while you steam iron (Fig. 5).
Tip: When you put down the iron during ironing, put it on its heel.
Note: If you have not used the steam function for some time, the steam that was still present in the
supply hose has condensed into water. When you start steam ironing again, this may cause some
spluttering in the appliance and a few droplets of water may escape from the soleplate.
Note: To prevent droplets from falling onto your garments, hold the iron over an old cloth and press the
steam trigger until the steam production has normalised before you start steam ironing again.
EnGlISh
9