Bravetti EP542 - Manual (Page 3)

3
OPERATING INSTRUCTIONS
Read all the sections of this booklet and follow all the instructions carefully.
Before Using for the First Time
1. Remove all promotional labels
from the drink maker. Wash
the container in hot soapy
water and dry thoroughly.
2. Clean the mixing blades and
shaft with a damp cloth and dry
thoroughly.
Warning: Do not immerse unit
in water or any other liquid for
cleaning.
Using the Drink Mixer
1. Place the drink maker on a level,
dry surface. Plug the unit into a
120 volt wall outlet.
2. Make sure that the 2 speed switch
is in the center (0) “Off” position
(Fig. A).
3. Combine the ingredients in the
container. Do not overfill the
container beyond the “MAX” line
(Fig. B).
4. Hold the container and place it
into the drink maker. Make sure
that the top of the container
is placed behind the upper
interlocking bracket that supports
the container (Fig. C). The base
of the container should rest on the
bottom bracket pressing on the
safety switch. (Fig. D).
5. Switch on the 2-speed electrical
switch.
6. Choose speed (l) or (ll) according
to the ingredients that you are
using. (Fig. E).
7. When your drink is ready, press
the 2-speed switch to the “OFF”
(0) position to stop the unit
(Fig. A).
8. Remove the container by lifting it
upwards slightly to release it from
the bottom bracket and serve.
Fig. B Fig. A
Fig. C Fig. D
Fig. E
OPERATING INSTRUCTIONS
1. To clean the blade, fill the container
with one (1) cup of warm water.
Operate the drink maker on speed
“1” as previously described in
operating instructions. Unplug unit
from wall outlet. Dry mixing blades
and shaft with a soft dry cloth.
2. Wipe the motor housing with a damp
cloth. Make sure that the cloth is not
excessively wet and that no moisture
enters the vents on the motor
housing.
3. Wash the container in warm, soapy
water.
Do NOT use abrasive cleaners of any
type to clean either the unit or the
container.
DO NOT IMMERSE THE APPLIANCE
IN WATER OR ANY OTHER LIQUID.
1. When preparing milk shakes
note that the volume of a milk
shake will vary according to the
type of milk used.
2. It is important to follow
guidelines in the recipes to
avoid spillage from the
container.
3. Always remember that solids
such as ice cream or fruit will
increase the volume of the milk
shake.
4. The container must always be
filled at least to half the distance
to the “MAX” line or the liquid
will not reach the blade.
5. When mixing do not fill above
the maximum level (8 oz./1
cup/250 ml) or liquid will
overflow.
6. For best results, all liquid
ingredients should be as cold as
possible.
7. All syrups and powdered mixes
should be added just before
mixing to prevent them from
sinking to the bottom of the
container.
8. The Drink Maker does NOT
crush ice. For best results, use
crushed ice if the recipe calls for
ice.
4
Cleaning Instructions
Warning: Always remove the
plug from the wall outlet before
cleaning or storing the unit.
never immerse the unit, cord
or plug in water or any other
liquid.
Hints