BBE DI-10 - Manual (Page 2)

Congratulations on the purchase of your
BBE DI-10 direct box!
The BBE DI-10 is an active direct box used for converting line out and
speaker out signals to balanced and unbalanced signals. The user also
has the ability to select between two frequency responses (flat, or
speaker compensated). Using the outputs from the DI-10, the user can
direct feed to a mixer, recorder, or sound reinforcement system.
The features that make up the BBE DI-10 are:
1. Speaker thru and Speaker input jacks.
2. 1/4” phone jack for line level signal input and output.
3. XLR jack for mic level, balanced output.
4. Filter switch to operate the speaker simulating filter.
5. Tri-mode powering for three different modes of powering:
a) internal 9V battery,
b) 9VDC external power source, and
c) 48V phantom power source through the XLR connector.
6. Tri-mode power scanning feature which scans the three power
sources and uses only the highest source of power and shuts off the
other power sources.
IMPORTANT
Before you begin, please check the contents within this box to insure
that included are:
1. The BBE DI-10.
2. Four (4) Rubber Feet for table-mount application.
3. The BBE DI-10 user’s manual.
4. 9VDC External Power Source.
Use the following illustrations as a starting point for proper placement
of the BBE DI-10.
i - BBE DI-10 INSTALLATION INSTRUCTIONS
LINE OUT
LINE IN
BALANCED OUTPUT
SPEAKER OUT
SPEAKER THRU
SPEAKER IN
BALANCED OUTPUT
DI-10
MIXING CONSOLE
PA SPEAKER
PA SPEAKER
AMP & SPEAKERS
DI-10
MIXING CONSOLE
PA SPEAKER
PA SPEAKER
AMP & SPEAKERS