Briggs & Stratton 28N700 - Manual (Page 6)

6
ENGINE PARTS
1. Oil drain
2. Oil fill/Dipstick
3. Rotating screen
4. Blower housing
5. Muffler/(Muffler guard, if equipped)/
(Spark arrester, if equipped)
6. 12 V electric starter
7. Air cleaner
8. In-line fuel filter (if equipped)
9. Carburetor
10. Oil filter (if equipped)
11. Spark plug wire
12. Engine Model Type Code
xxxxx xxxx xx xxxxxxxx
3
4
5
6
2
9
7
8
10
11
1
12
GENERAL INFORMATION
ENGINE MODEL
This is a single cylinder, overhead valve (OHV), air-cooled
engine. It is a low emissions engine.
In the state of California, OHV Model Series 280000 and
310000 engines are certified by the California Air Re-
sources Board to meet emissions standards for 250 hours.
Such certification does not grant the purchaser, owner or
operator of this engine any additional warranties with
respect to the performance or operational life of this engine.
This engine is warranted solely according to the product
and emissions warranties stated elsewhere in this manual.
MODEL SERIES 280000
Bore 3-7/16 in. (87.31 mm) . . . . . . . . . . . . . . . . . . . . . . . . . .
Stroke 3-1/16 in. (77.78 mm) . . . . . . . . . . . . . . . . . . . . . . . .
Displacement 28.42 cu. in. (465.7 cc) . . . . . . . . . . . . . . . .
MODEL SERIES 310000
Bore 3-9/16 in. (90.60 mm) . . . . . . . . . . . . . . . . . . . . . . . . . .
Stroke 3-1/16 in. (77.78 mm) . . . . . . . . . . . . . . . . . . . . . . . .
Displacement 30.59 cu. in. (501.2 cc) . . . . . . . . . . . . . . . .
Note: For practical operation, the horsepower loading should
not exceed 85% of rated horsepower. Engine power will de-
crease 3-1/2% for each 1,000 feet (300 meters) above sea
level and 1% for each 10
°
F (5.6
°
C) above 77
°
F (25
°
C).
Engine will operate satisfactorily at an angle up to 15
°
.
THE INTERNATIONAL SYMBOLS USED
ON THE ENGINE OR
IN THIS MANUAL INCLUDE:
On Off
Fuel Shutoff
Read Owner’s
Manual
Stop
Fuel Choke
Safety Alert
Oil
TUNE-UP SPECIFICATIONS
Armature air gap 0.010 – 0.014 in. (0.25 – 0.36 mm) . . .
Spark plug gap 0.030 in. (0.76 mm) . . . . . . . . . . . . . . . . . .
Valve clearance with valve springs installed and piston 1/4 in.
(6 mm) past top dead center (check when engine is cold).
See Repair Manual P/N 272147 or 274008.
Intake 0.003 – 0.005 in. (0.08 – 0.13 mm) . . . . . . . . . . . . .
Exhaust 0.005 – 0.007 in. (0.13 – 0.18 mm) . . . . . . . . . . .