Bosch HBN 74 - Manual (Page 8)

PB
WALL INSTALLATION, DOUBLE OVEN
Note: 1. Do not slide oven across floor. Damage
to floor covering or floor could result.
2. The oven support surface must be a mini-
mum 3/4" thick plywood platform, solid,
level and flush with the bottom of the
cabinet cutout.
3. Use extreme caution when moving or in-
stalling the oven. It is very heavy.
4. Be very careful when moving or install-
ing the oven to avoid damage to the oven
frame or damage to the cabinets.
5. Be sure to level the oven. An oven that is
not level may provide poor or inconsis-
tent baking results.
6. Be careful when placing oven. DO NOT
pinch the conduit between the oven back
or wall and the inner cabinet wall or floor.
Secure oven to cabinet using the screws provided. Screws should be in-
serted through the mounting holes in the positions indicated in the frame
(open door to see frame and mounting holes). Do not overtighten screws.
22" depth
47-5/8"
Electrical
supply
junction
box
24" opening
depth
1" min.
47-13/16" opening height
1/4" min.
Securely fasten oven to cabinet using the
screws provided. Failure to do so could result
in oven moving or tipping during use and caus-
ing damage to the oven or cabinets or personal
injury.
WARNING
MISE EN GARDE
Fixez bien le four à l’armoire à l’aide des vis
fournies. Si vous ne le faites pas, cela pourrait
résulter en un déplacement ou un basculement
du four et pourrait endommager le four, les
armoires ou encore causer des blessures.
* HBL: HBL 73../74../75../76..
* HBN: HBN 74../75../76..
* HBL:
29-1/4" width
* HBN:
26-5/8" width
* HBL: 28" opening width
* HBN: 25-3/8" opening width
48" height