Philips Azur Fer vapeur User Manual
Page 9
ironing without steam
1
Set the steam control to position 0 (= no steam) (Fig. 2).
Do not use the Ionic DeepSteam function, as this function has no effect when you iron without steam.
2
Set the required ironing temperature (see chapter ‘Preparing for use’, section ‘Setting the
temperature’).
after ironing
1
Remove the mains plug from the wall socket.
2
If you have been steam ironing, empty the water tank.
3
Let the iron cool down in a safe place.
Features
Spray function
You can use the spray function at any temperature to moisten the article to be ironed. This helps
remove stubborn creases.
1
Make sure that there is enough water in the water tank.
2
Press the spray button several times to moisten the article to be ironed (Fig. 10).
steam boost function
A steam boost from the special Steam Tip soleplate helps remove stubborn creases. The steam
boost enhances the distribution of steam into every part of your garment.
The steam boost function can only be used at temperature settings between 3 and MAX.
1
Press and release the steam boost button (Fig. 11).
vertical steam boost
1
You can also use the steam boost function when you hold the iron in vertical position. (Fig. 12)
This is useful for removing creases from hanging clothes, curtains etc.
Never direct the steam at people.
Drip stop
This iron is equipped with a drip-stop function: the iron automatically stops producing steam when
the temperature is too low, to prevent water from dripping out of the soleplate. When this happens,
you may hear a sound.
Automatic shut-off function (specific types only)
, The red AUTO/OFF indication of the temperature light flashes to indicate that the iron has
been switched off by the automatic shut-off function.
To let the iron heat up again:
1
Pick up the iron or move it slightly.
, The red AUTO/OFF indication goes out.
, If the temperature of the soleplate has dropped below the set ironing temperature, the
amber temperature light goes on.
2
If the amber temperature light goes on after you have moved the iron, wait for it to go out
before you start ironing.
EnGlish
9