Bosch UC MCM 5200 - Manual (Page 23)

23
TROUBLESHOOTING
Problem Possible Cause Remedy
Power 1.A circuit breaker may have Reset circuit breaker or
unit does tripped or a fuse has blown replace fuse.
not in the power supply circuit.
function
2.Safety motor drive cover is Place safety motor drive cover on
not in place on high speed, high speed blender drive.
blender drive, when dual
drive is being used.
3.The built-in safety cutout If the safety has tripped due to
may have tripped. overheating:
> Turn the power unit to the Off
position, “O/Off,” and unplug.
> Remove the attachment that was
in use when safety tripped, and
correct whatever the situation
is that caused the safety to trip.
> Contact Bosch Small Appliances
Customer Support, see page 22,
for closest Bosch authorized
service center.
> Take, or ship, the food processor
to a Bosch authorized service
center to have the safety cutout
replaced.
Rotary switch 1.Safety cover interlock is not Safety cover interlock must be
will not turn engaged. engaged before rotary switch can
be turned. Rotate bowl cover or
juicer tab clockwise until interlock
tabs clicks into place.
Power 1.The motor has become > Turn the power unit to the Off
unit hums blocked; that is, the position, “O/Off,” and unplug.
but attachment being used has > Remove the attachment
nothing is become jammed. that was in use and correct
moving whatever the situation is that
is causing the blockage.
> Reinstall the attachment and
resume use per attachments
instructions.