Philips PerfectCare Pure Cartouche anticalcaire User Manual
Page 10
Energy saving
ECo mode
By using the ECO mode (reduced amount of steam), you can save energy
without compromising on the ironing result.
1
To activate the ECO mode, press the ECO button. The light in the
ECO button goes on.
2
To switch back to the ‘OptimalTemp’ setting, press the ECO button
again.
For the shortest ironing time, we advise you to use the ‘OptimalTemp’
setting.
Safety auto-off (specific types only)
The safety auto-off function automatically switches off the appliance if it has
not been used for 5 minutes, to save energy.
IMPoRTANT: Replacing the ANTI-CALC cartridge
ANTI-CALC replacement light
It is very important that you replace the ANTI-CALC cartridge when
the ANTI-CALC cartridge replacement light starts flashing and the
appliance starts beeping.
Note: The cartridge lasts 3 months on average, but this depends on the
hardness of the water you use and on how many hours you iron.
- The ANTI-CALC replacement light starts flashing and the appliance
starts beeping to indicate that the ANTI-CALC cartridge needs to be
replaced.
- You can still continue steam ironing for 15-30 min. (depending on
the hardness of the water used) when the ANTI-CALC replacement
light flashes and the appliance beeps. However, the steam output will
diminish and ultimately the steam generator stops producing steam to
prevent scale build-up that would permanently damage your appliance.
- To let the appliance produce steam again, you have to replace the
ANTI-CALC cartridge. If you do not want to replace the ANTI-CALC
cartridge, you have to use demineralised water or descaled water from
the IronCare. In that case, you need to leave the exhausted cartridge in
the compartment.
Replacing the ANTI-CALC cartridge
1
Switch off the appliance and let it cool down.
2
Follow the steps in chapter ‘Before first use - Placing the ANTI-
CALC cartridge’.
ENGLIsh
10