BT 1800 - Manual (Page 12)

➜
Insert the CD installation software for the
BT On-Air 1800 into your CD ROM drive.
Do NOT run the CD now. Instead, follow
steps below to start installation
➜
Plug the BT On-Air USB unit into a free
USB port identified by the symbol below
on your computer.
Windows will automatically detect the
BT On-Air USB unit. (If this does not happen
see Help, page 48.)
After a few seconds, the screen will then
display Add New Hardware Wizard ready to
search for the USB Wireless Modem driver.
➜
Click Next>
12
BT On-Air USB unit
Note
Do not attach the BT On-Air USB unit with
the sticky patch yet. Wait until after software
installation when you will be able to check
the strength of the signal using the BT On-Air
monitor.
Note
The BT On-Air drivers and software must be
installed on your computer before you can use
your BT On-Air 1800 to connect to the Internet.
Installation instructions vary according to your
operating system.
- See below for Windows 98
- Page 14 for Windows Me
(i.e. Millennium Edition)
- Page 15 for Windows 2000
- Page 16 for Windows XP
See Help on page 48 if you are experiencing
problems during installation.
Important
If an external USB hub is used to plug the
BT On-Air USB unit into your computer, it
must be one that is mains powered.
➜
Switch on your computer and close any
open applications.
1a Drivers Installation for
Windows 98
1