Barbie LIL' TRAIL RIDER K0451 - Manual (Page 11)

J7825a-0920
3
4
1
11
K0451pr-0921
BATTERY INSTALLATION
IMPORTANT! Use only a Power Wheels ® 6 volt (4.0 Amp/Hr.)
battery and built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery for
at least 18 hours using the enclosed Power Wheels
® 6 volt
(4.0 Amp/Hr.) charger before operating your vehicle for the
first time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than 30
hours. Failure to follow these instructions may damage your
battery and will void your warranty.
2
• Loosen the screw in the battery retainer and remove it.
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener
1 / 4 turn to
the unlocked position .
• Lift the seat from the vehicle.
Battery
Retainer
Lock
Fastener
Seat
Unlocked
6 Volt
Battery
Battery
Compartment
Battery
Retainer
Battery
• Fit the Power Wheels ® 6 volt (4.0 Amp/Hr) battery inside the
battery compartment with the wires facing towards the rear of
the vehicle.
• Place the battery retainer over the battery.
• Replace the screw through the end of the battery retainer and
into the vehicle.
• Tighten the screw with a Phillips screwdriver. Do not
over-tighten.