Bacharach Infrared Printer - Manual (Page 12)

Instruction 24-9450 8
Maintenance IrDA Printer
Maintenance
Battery Installation
Install four ‘AA’ alkaline batteries as follows:
1. Turn OFF printer.
2. Unlatch and remove battery cover from bottom of printer.
3. Remove old batteries and dispose of them properly.
4. Insert four ‘AA’ alkaline batteries, observing the polarity marked inside
the battery compartment.
5. Install battery cover.
Paper Installation
When the printer runs out of paper as indicated by the front panel red
LED flashing, install a new paper roll as follows:
1. Lift up paper-cover latch, and then open paper cover as shown in
Figure 3.
2. Remove spent paper core.
3. Drop in a new paper roll so that it will rotate in the direction shown.
4. Close paper cover so that the paper is pinched between the paper roller
and print head. Remove any slack by pulling out about ½ inch of paper
from printer.
Note: If there was unprinted data in memory when the
paper ran out, and the printer was not shut OFF, then the
printer will automatically print the remaining data 5 sec-
onds after closing the paper cover.