Bose SoundLink AM319182 - Manual (Page 15)

11
C ARE AND M AINTENANCE
TAB 5, 13 TAB 4, 12 TAB 6, 14 TAB 8, 16 TAB 7, 15 English TAB 3, 11 TAB 2, 10
4. Plug the battery into the multi-pin connector.
5. Push in the slotted knob and turn it clockwise until
the slot is vertical.
6. Connect the power supply and charge the battery.
Replacing the remote battery
When the remote stops operating or its range seems
reduced, it is time to change the remote battery. Replace
it with type CR2032 or DL2032.
1. Using a coin, turn the battery
cover slightly counterclockwise.
2. Remove the used battery and
insert the new one. Be sure the
battery is plus (+) side up.
3. Reseat the cover and turn it
clockwise until it locks into place.
WARNINGS:
• Keep the remote control battery away from children. It may
cause a fire or chemical burn if mishandled. Do not recharge,
disassemble, heat above 100ºC (212ºF), or incinerate.
• Dispose of used batteries promptly. Replace only with a battery
of the correct type and model number.
• Danger of explosion if battery is incorrectly replaced. Replace
only with Duracell, Eveready, Energizer, Maxell, Toshiba, or
Shun Wo CR2032 or DL2032 3-volt lithium battery.
Cleaning
To clean the exterior surface of your product, you can
wipe it using a soft, dry cloth. You can also lightly
vacuum the grille.
• Do not use solvents, chemicals, or sprays.
• Do not allow liquids to spill or objects to drop into any
openings.
Troubleshooting
If you experience difficulty with your SoundLink™
wireless music system, use the following table to try
to solve the problem. If the problem persists, see
“Contacting customer service” on page 14.
PharosOG.book Page 11 Thursday, May 21, 2009 10:09 AM