Philips PerfectCare Pure Centrale vapeur - Manual (Page 8)

Preparing for use
Filling the water tank
- Fill the water tank before every use or when the water level in the
water tank drops below the minimum level. You can refill the water
tank at any time during use.
- Make sure you only use one of the 3 types of water mentioned below
to fill the water tank:
1 Tap water
The ANTI-CALC cartridge filters scale particles from tap water. The scale
content in the filtered water is regularly monitored by an electronic sensor.
This sensor informs you when the cartridge needs to be replaced.
2 Demineralised water
You can safely use demineralised water in your steam generator. Make sure
that the ANTI-CALC cartridge is always in place, as the cartridge serves as
a link between the water tank and the iron. When you use demineralised
water, the ANTI-CALC cartridge is not used and therefore replacement of
the cartridge is not necessary.
3 Descaled water from the IronCare
The IronCare removes scale from tap water to ensure optimum
performance for your iron. For more information, go to
www.philips.com/ironcare.
Caution: Do not use perfumed water, water from a tumble dryer,
rainwater, vinegar, mineral water, magnetically treated water (Aqua+),
water from a drinking water filter, starch, descaling agents, ironing
aids, salt or chemicals in the water tank. These types of water have
been tested. They are not suitable and may even cause damage to the
appliance. If you use any of these types of water, your guarantee becomes
invalid.
1 Open the filling funnel lid.
2 Fill the water tank with tap water up to the MAX indication. Then
close filling funnel lid (‘click’).
EnGlish
8