Bushnell HARBORMASTER 78-6035 - Manual (Page 2)

(fig. 1)
Leg and attach wingnut. Wingnuts should be positioned
beneath the Accessory Tray . Do not tighten wingnuts
until all Accessory Tray Braces are attached as some
adjustments may be required.
• Select one Tripod Leg (5) and extend the Tripod Leg
Middle Section (6) . Using Tripod Leg Lock Screws (9)
included in the hardware pack, insert the Tripod Leg
Lock Screw into the lower brackets on the Tripod Leg .
Tighten the Tripod Leg Lock Screws so that the middle
section is securely in place. Repeat on remaining
two legs.
2. Attach Telescope
• Locate Telescope Main Tube (2) . Secure telescope to
Altazimuth Yoke Mount (3) by positioning the telescope
between yoke. Carefully insert the Altitude Lock Knobs
(11) through the yoke mount and into the threaded
brackets on the side of telescope tube and remove lens
cover from
60mm Objective Lens (1).
Your Bushnell Telescope is now ready to be used.
To obtain the fullest enjoyment from your
telescope, please refer
to the additional
information below.
HOW TO USE YOUR NEW TELESCOPE
Focusing Telescope:
1.After assembly, aim
Telescope Tube (2) at a land-based
target at least 200 yards away (e.g. a lighthouse or
landscape). Fully extend
focusing tube (10).
2.While looking through eyepiece slowly adjust focusing
tube (10) by sliding telescoping tube inward until object
comes into focus in the eyepiece.
Never Look Directly At The Sun With Your Telescope
Permanent Damage To Your Eyes May Result.
TELESCOPE LIFETIME LIMITED WARRANTY
Your Bushnell ® telescope is warranted to be free of defects in materials and
workmanship for the lifetime of the original owner. The Lifetime Limited
Warranty is an expression of our confidence in the materials and mechanical
workmanship of our products and is your assurance of a lifetime of
dependable service.
If your telescope contains electrical components the electronic components
are warranted to be free of defects in materials and workmanship for one
year after the date of purchase.
In the event of a defect under this warranty, we will, at our option, repair or replace
the product, provided that you return the product postage prepaid. This warranty
does not cover damages caused by misuse or improper handling, installation or
maintenance of the product.
Any return made under this warranty
must be accompanied by the items listed below:
1) A check in the amount of $15.00 to cover the cost of handling
2) Name and address for product return
3) An explanation of the defect
4) Product should be well packed in a sturdy outside shipping
carton to prevent damage in transit and return postage prepaid
to the address listed below:
IN U.S.A. Send To:
Bushnell Performance Optics
8500 Marshall Drive
Lenexa, Kansas 66214
For products purchased outside the United States and Canada please contact
your local dealer for applicable warranty information. This warranty gives
you specific legal rights. You may have other rights which vary from country
to country.
©2001 Bushnell Performance Optics
IN CANADA Send To:
Bushnell Performance Optics
25A East Pearce Street, Unit 1
Richmond Hill, Ontario L4B 2M9
WARRANTY / REPAIR
2