BOXLIGHT CP300T - Manual (Page 2)

Smart Classroom Operations Guide Academic Computing - College of Charleston revised: 1/10/2005:jpva
Instructions for Boxlight CP300T
If….
• The Computer will not turn on
Then try the following steps…
1) CHECK the POWER SWITCH located INSIDE THE RIGHT
CABINET OF THE NOVA STATION. It should light up RED
to indicate that the computer is receiving power
2) If the Nova station has power, reset the computer by pressing the
reset button on the front of the computer.
3) CHECK THE WALL OUTLET to make sure that the power is
plugged in from the Nova Desk.
4) Check to make sure that the power connection in the back of the
computer is firmly seated.
5) If you are unable to resolve the problem, CALL THE
HELPDESK AT 953-3375. Please use guidelines provided
at the end of this Operations Guide to assist you when
placing a Help Desk call.
If….
• The computer is on but the image is NOT projecting on the
screen
• The VCR is not projecting on the Screen
• The Projector Remote Control Unit does not work
• The Projection Unit will not turn on
Then try the following steps…
1) Turn the projector bulb on by pressing the Standby/On (green)
button on the remote control.
2) When turning on the projector, it takes about 30 SECONDS
TO DISPLAY AN IMAGE. If the IMAGE DOES NOT
APPEAR after 30 Seconds:
3) Turn off the fluorescent lights in the room (they can cause
interference with the remote) and begin at step 1.
Power Switch