Liebherr CBNPes 3756 Premium BioFresh NoFrost - Manual (Page 6)

u Remove the protective film from the outside of the appli-
ance.
NOTICE
The stainless steel doors are provided with a high-quality
surface coating and must not be treated using the accompa-
nying care product.
Otherwise the surface coating will be affected.
u Wipe the coated door surfaces using a soft, clean cloth
only.
u Apply a stainless steel cleaner only to the stainless steel
side walls evenly, wiping with the grain. Subsequent
cleaning becomes easier as a result.
u Wipe side walls with a paint finish using a soft, clean
cloth only.
u Remove the protective film from the decorative trims and
drawer fronts.
u Remove all transit supports.
The spacers supplied with some appliances must be used to
achieve the stated energy consumption. These will extend the
depth of the appliance by approx. 35 mm. The appliance is fully
functional if the spacers are not used, but does have a slightly
higher energy consumption.
u In the case of an appliance with
enclosed wall spacers, mount the
wall spacers on the back of the
appliance at the top left and right.
u Dispose of packaging material (see 4.5) .
u Align the appliance so that it
stands firmly and on a level by
applying the accompanying
spanner to the adjustable-
height feet (A) and using a
spirit level.
u Then support the door: Extend
the adjustable foot at the turn
hinge (B) until it rests on the
floor and then make a further
90° turn.
Note
u Clean the appliance (see 6.2) .
If the appliance is installed in a very damp environment,
condensate may form on the outside of the appliance.
u Always see to good ventilation at the installation site.
4.3 Changing over the door hinges
You can change over the door hinges if necessary.
Ensure that the following tools are to hand:
q Torx® 25
q Torx® 15
q
Screwdriver
q
Cordless screwdriver, if necessary
q Second person for fitting work, if needed
4.3.1 Detaching the upper door
Note
u Remove any food from the door racks before removing the
door, so that no food falls out.
Fig. 4
u Close the upper door.
u Pull off the cover Fig. 4 (1) forwards and upwards.
u Lift off the cover Fig. 4 (2) .
CAUTION
Risk of injury if the door tips!
u Take good hold of the door.
u Set down the door carefully.
u Unscrew the upper turn hinge Fig. 4 (3) (2x Torx® 25)
Fig. 4 (4) and lift it off.
u Lift up the upper door and set it aside.
4.3.2 Detaching the lower door
u Close the lower door.
u Draw the middle bearing pin Fig. 5 (11) out of the turn hinge
and lower door.
u Remove the plastic cap Fig. 5 (10) .
CAUTION
Risk of injury if the door tips!
u Take good hold of the door.
u Set down the door carefully.
u Open the lower door.
u Unscrew the middle turn hinge (2x Torx® 25). Fig. 5 (13)
u Lift up the door and set it aside.
4.3.3 Transferring the middle bearing elements
Fig. 5
Putting into operation
6 * Depending on model and options