Liebherr LTM 1200-5.1 - Manual

PN 1200-5.1_D-GB/F/I/ESP/RUS 03.07.2007 10:09 Uhr Seite 1
Probedruck
C M Y CM MY CY CMY K
Liebherr-Werk Ehingen GmbH
Postfach 1361, D-89582 Ehingen
ట +49 7391 5 02-0, Fax +49 7391 5 02-33 99
www.liebherr.com, E-Mail: [email protected]
LTM 1200-5 .1 Mobile crane
Product advantages
Max. load capacity: 200 t
Max. height under hook: 98 m
Max. radius: 82 m
Subject to modifications. PN 155.01.E07.2007
Electric/electronic PLC crane control with test system
• Control of the winches, slewing gear and the luffing and
telescoping motions by the LICCON computer system
(PLC control)
• Four working motions can be performed independent from one
another
• Speeds for lifting/lowering, luffing and slewing preselectable
by 5 steps
• Very short response rates at the activation of crane motions
• Hoist gear and slewing gear are operating within a "closed
oil circuit". This enables very sensitive lifting/lowering of
loads, or slewing. Moreover, during lowering of the load, the
generated potential engergy is not converted into heat but
can be re-employed, for a 2nd motion This saves fuel and
the oil is less thermically exposed than by operation within
the open circuit.
• Functional test of all essential components by means of the
LICCON test system
On the carrier
• Additional heater with engine preheating
• Eddy-current brake
• Supporting force indicator on the carrier and in the operator’s
cab
• Stow-away box
• Air-conditioning system
• Trailer coupling D12/D19
• Radio preparation
• Seat heating for driver’s and co-driver’s seat
• CD radio set
On crane superstructure
• Additional heater with engine preheating
• 2nd hoist gear
• Air-conditioning system
• Seat heating
• Work area limitation
• Aircraft warning light
• Working projectors (xenon) – electric adjustment – on the
boom base section
• GSM module for tele-diagnostic
• CD radio set
• Emergency actuation
Further optional features by request.
Optional features contribute to an expansion of the application spectrum
and increase comfort and safety
Luffing ram
Liebherr-
hoist winch I
Single-stage
telescoping
ram with
hydraulic
interlocking
device Joystick
selector
Engine
control
Control block
LICCON
monitor
3 variable
displacement pumps Diesel engine D934S A6
Transmitters
1 double variable
displacement pump
Sensors
Liebherr-
hoist winch II
LICCON-
control
Liebherr
slewing gear