Liebherr G 2433 Comfort - Manual (Page 3)

9
Dimensions
(mm)
Setting up
• Do not place the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
• The floor on which the appliance stands should be horizontal and
level. To compensate for any unevenness, adjust the height of the
feet with the open-ended spanner supplied.
• Always ensure good ventilation. Do not cover ventilation openings
or grille.
• Do not place heat-emitting appliances, e.g. microwave oven,
toaster, etc., on top of the freezer.
• Standard EN 378 specifies that the room in which you install your
appliance must have a volume of 1 m 3 per 8 g of R 600a refrigerant
used in the appliance, so as to avoid the formation of inflammable
gas/air mixtures in the room where the appliance is located in the
event of a leak in the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type plate on the inside
of the appliance.
GB
G 20 H = 1250 mm
G 24 H = 1447 mm
G 27 H = 1644 mm
Saving energy
- Always ensure good ventilation. Do not cover ventilation openings
or grille.
- Do not place the appliance in direct sunlight or near cookers,
radiators and similar sources of heat.
- The energy consumption depends on the installation conditions,
e.g. the ambient temperature.
- Keep the time the appliance is open to a minimum.
- Store food logically.
- Keep all food properly packed and covered so as to avoid its
frosting up on the outside.
- Always allow hot food to cool to room temperature before placing
in the appliance.
- If there is a thick layer of frost in the appliance: defrost the appli-
ance.
Accumulated dust increases the energy consumption:
- Once a year, dust the refrigeration unit together with the metal
grid of the heat exchanger at the back of the appliance.
Climate rating
The climate rating indicates the room tem-
perature at which the appliance may be
operated in order to achieve full refrigeration
performance.
The climate rating is indicated on the type
plate.
The position of the type plate is shown in
the description of the appliance.
Climate rating Room temperature
SN +10°C to +32°C
N +16°C to +32°C
ST +16°C to +38°C
T +16°C to +43°C
SN-ST +10°C to +38°C
SN-T +10°C to +43°C
Do not operate the appliance outside the specified room
temperature range.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on the type
plate. The position of the type plate is shown in the description of
the appliance.
The socket must be properly earthed and protected by a fuse.
The tripping current of the fuse must be between 10 A and 16 A.
The socket must not be situated behind the appliance and must
be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conversion of
d.c. to a.c./three-phase) or energy saving plugs.
Risk of damage to the electronic control system!