Warning, Ssembly, Locate and install filters – Bissell 61C5-G User Manual

Page 5: Attach handle to vacuum, Attach the vacuum hose & tools

Advertising
background image

The only tool you’ll need to assemble your

vacuum cleaner is a Phillips screwdriver.

Locate and install filters

ImPORTANT: before using your vacuum, make

sure that all filters (pre-motor and post-motor) are

in place. do not operate your vacuum without

these filters. your total floors vacuum comes pre-

loaded with a post-motor foam filter. if you wish

to use the post-motor febreze® filter instead,

locate the febreze® filter in the vacuum carton

and remove the filter from its packaging. next,

remove the post-motor foam filter from the filter

door and insert the febreze® filter in its place as

is shown to the right (a). do not use your vacuum

without one of these filters in place. do not use

both filters together.

Attach handle to vacuum

1. locate the carry handle. Remove the screw

packet taped to the carry handle. there are

three screws in this screw packet. two screws

are used to attach the upper handle and car-

rying handle to the vacuum base. one screw

is used to attach the hose guide/tool caddy.

2. stand the vacuum upright. from the back

of the vacuum body, slide the base of the

upper handle firmly into the grooves at the

top of the vacuum body. continue to push

so that there are no gaps and the front of

the handle is flush with the vacuum body.

3. With the upper handle firmly placed on the

vacuum body, guide the carrying handle

into place onto the back of the upper handle

and insert two of the screws into the existing

holes. (Reference the rear-facing product

view on page 4 to see how the carry handle

should look). tighten screws securely with

a phillips screwdriver to anchor the carry

handle to the upper handle and the upper

handle to the vacuum body.

Attach the vacuum hose & tools

1. attach the 3 hose/tool storage pieces to the

back of the unit.

a. attach the tool storage clip to the back of

the handle by snapping the piece into the

unit as shown. push piece straight in until

it snaps into place.

b. attach the hose guide clip to the left side

of the back of the vacuum. insert tab at a

45 degree angle and turn clockwise so it

snaps into place.

w w w. b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1

A

ssembly

5

WARNING:

plastic film can be dangerous.

to avoid danger or suffocation,

keep away from babies

and children.

A.

1.

2.

3.

a.

b.

c.

Advertising