Philips QuickTouch Défroisseur - Manual (Page 14)

14
Problem Possible cause Solution
EN The appliance does not
heat up.
There is a connection problem Check the mains plug and the wall socket.
You have not switched on the appliance. Press the on/off button to switch on
the appliance.
The appliance does not
produce any steam.
The steamer has not heated up sufficiently. Let the appliance heat up for approx.
2 minutes.
Steam has condensed in the hose. Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
The water level is below the MIN level
indication.
Fill water tank to the MAX level indication.
You have placed the steamer on a table
or chair instead of on the floor.
Place the steamer on the floor.
The steam output is
irregular.
Steam has condensed in the hose or in
the steamer head.
Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
You have placed the steamer on a table
or chair instead of on the floor.
Place the steamer on the floor.
Water droplets drip from
the steamer head.
Steam has condensed in the hose. Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
You have left the steamer head and/or the
steam supply hose in horizontal position
for a long time.
Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
You have placed the steamer on a table or
chair instead of on the floor.
Place the steamer on the floor.
The appliance produces
a croaking sound.
When the hose forms a U-shape, con-
densation present in the hose cannot flow
back into the water tank.
Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
You have left the steamer head and/or the
steam supply hose in horizontal position
for a long time.
Lift the steamer head to straighten the hose
vertically. This allows any condensation to
flow back into the water tank.
Water spills out of the fill-
ing opening when the
cap is closed.
You have put too much water in the
water tank
Do not fill the water tank above the MAX
levelindication.
An excessive amount of
water drips out of the
steamer head when the
appliance is heating up.
The water in the appliance is dirty or
has been left inside the appliance for
a long time.
Remove all water from
the water tank and
rinse it with clean water, see